Publicidad
Idiomas disponibles
Idiomas disponibles
II
Preparation
Use
Type I (normal)
tapes only.
o Set the tape to the point where recording
will start.
* Note that recording
is
done on only one side of the tape.
7 Insert the tape to be recorded on into Deck 1.
Insertthetape with theside tobe
recorded on first facing out
from the unit.
WA
1)
...............
e
! I ! !
2
3
Press one of the function buttons and prepare
the source to be recorded.
~
record from a CD, press CD and load the disc(s).
~record
from a tage, press TAPE. Then, insert the original
tape into Deck 2 and play it.
To record from a radio broadcast, press TUNER/BAND and
tune into a station.
To record from a connected
source, press PHONO or
VIDEO/AUX and play.
Press
cm Deck 1 to start recording.
> is depressed simultaneously.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press
/A on Deck 1.
To pause recording,
press II on Deck 1.
'To resume recording, press it again.
To record selected tracks of the CD
Before pressing
, program
the tracks (page 14).
To record part of the CD
When
is pressed,
recording
always starts from the first track.
To start in the middle of a track, play the CD first and press 1I SET
for
CD
at the point you wish to start recording from. Then, press
..-rhe
pause mode for CD button is released automatically and
recc)rding starts.
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting the recording.
mm
Dc) not press the buttons on Deck 2 during recording.
cannot be depressed if the erasure prevention tab on the
side of the tape to be recorded is broken off.
To
erase a recording
A previous recording is erased when a new recording is made
on that part of that tape.
1
Insert the tape you want to erase into Deck 1.
2 F)ress TAPE and stop all the tape operation in Deck 2.
3 Windup the tape to the point where the erasure is to be started.
4 F'ress
on Deck 1 to start the erasure.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
"120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
ENGLISH ~ ~
Publicidad
