Publicidad
Idiomas disponibles
Idiomas disponibles
3-
\
,—,/
–(
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
Press one of the function
buttons to select a
source.
If TUNER/BAND is pressed, the band cannot be selected in
this step.
Press TIMER to display @l and (! PLAY.
When
using the remote control, press TIMER while pressing
SHIFT.
Time and audio
source
name
flash
alternately.
e
~thin
6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or 11.
Turning
MULTI JOG changes both the hour and the minute.
~<
or -
is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
4 ~thin
4 seconds, turn MULTI JOG to select
duration for the timer-activated
period.
the
The duration can be set between 5 and 240 minutes in 5-
mirrute steps.
-
or -
is also available instead of MULTI JOG.
5
6
7
8
Adjust the volume.
a
The source sound will play at the volume level set in this step
when the power is turned on by the timer.
#
If the volume level is set to 21 or higher, however, it will
:;~'
automatically be set to 20 when the power is turned on,
:~;
Prepare the source.
:,$j
.,, :,,.
To listen to a CD, load the disc to be played first on tray 1.
!:&
To listen to a tape, insert the tape into deck 1 or 2.
~
To listen to the radio, tune in to a station.
o
Press POWER to turn off the power.
@
remains on the display after the power is turned
off (timer
standby
mode) if the power-economizing
mode is OFF.
Get ready for the TAPE function
or the timer
recording.
To listen to the tape, press > on Deck 1 or 2.
To record the source,
insert the tape into
Deck 1 and press
O on Deck 1.
VVhen the timer-on time is reached, the unit turns on and
begins play with the selected source.
mm
You can change
the source
that was selected
in step 1 by
pressing
one of the function
buttons
before pressing
ENTER
or II in ster3 3.
If the power-economizing
mode is ON, @ is not displayed in
thf? timer standby mode.
The timer recording period and tape length
Wh[?n the length of the tape to be recorded is shorter than the
timer recording period,
on deck 1 is released before the timer
is off.
Wh[?n the tape length is longer than the timer recording period,
is not released. If
is not released for a long time, the tape
in the deck may be damaged. Press WA
to release
.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or II is pressed within 4 seconds after
Stc?p4.
/ENGL/SH
19
Publicidad
