Promaker PRO-PC1200 Manual Del Usuario página 4

ASSEMBLY AND OPERATION
WARNING
• Disconnect the plug from the
power source before making any
adjustments, changing accessories or
storing the tool.
•To avoid electrical hazards, fire
hazards or damage to the Heat Gun,
use proper circuit protection.
• Do not abuse the cord. Never use the
cord to carry the tools or pull the plug
from an outlet. Keep cord away from
heat, oil. sharp edges or moving parts.
Replace damaged cords immediately.
NOTE: If air flow is blocked to nozzle,
causing overheating, the gun will turn
off and come back on when it has
cooled. DO NOT leave gun unattended
when it has stopped, since it will restart
and could cause fire or injury.
Important Safety Instructions
The warnings,
instructions discussed in this manual
cannot cover all possible conditions
and situations that may occur. The
operator must
common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
WARNING
This product, when used for soldering
and similar applications, produces
chemicals known to the State of
California to cause cancer and birth
defects or other reproductive harm.
All manuals and user guides at all-guides.com
precautions, and
understand that
TOOL USE AND CARE
1. Use clamps or another practical way
to secure and support the workpiece to
a stable platform. Holding the work by
hand or against your body is unstable
and may lead to loss of control.
2. DO NOT force the tool. Use the
correct tool for your application. The
correct tool will do the job better and
safer at the rate for which it was
designed.
3. DO NOT use the tool if the power
switch does not turn it ON or OFF.
Any tool that cannot be controlled with
the switch is dangerous and must be
repaired.
4. Disconnect the plug from the
power source before making any
adjustments, changing accessories
or storing the tool. Such preventive
safety measures reduce the risk of
starting the tool accidentally.
5. Store idle tools out of reach of
children and other untrained persons.
Tools are dangerous in the hands of
untrained users.
6. Maintain tools with care. Keep
cutting tools sharp and clean. Properly
maintained cutting tools with sharp
cutting edges are less likely to bind
and are easier to control.
7. Check for misalignment or binding
of moving parts, breakage of parts
and any other condition that may
affect the tools operation. If damaged,
have the tool serviced before using.
Many accidents are caused by poorly
maintained tools.
4