Concept VS 5023 Manual página 23

ACKNOWLEDGMENT
Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its
service life.
Please study the entire Operating Manual carefully before you start using the product. Keep the manual
in a safe place for future reference. Make sure other people using the product are familiar with these
instructions.
Voltage
Power input
Noise level
IMPORTANT SAFETY PRECAUTIONS
• Do not use the unit differently than described in this manual.
• Remove all packing and marketing material from the unit before you use it for the first time.
• Verify that the mains voltage corresponds with the values indicated on the unit label.
• Place the unit on a stable surface, away from other sources of heat.
• Do not leave the unit unattended while it is turned on or plugged into the power supply socket.
• When plugging and unplugging the unit into and from the socket, the mode selector must be in the 0 (off )
position.
• Never hold the power cord when disconnecting the unit from the socket; grasp and pull the plug, not the
cord.
• Do not allow children or legally incapacitated people to handle the unit; the appliance must be used out of
reach of such persons.
• Any physically challenged persons, persons with reduced sensory perception or insufficient mental
capacity, or persons who have not been familiarized with the operation may only use the unit under the
supervision of a responsible, instructed person.
• Exercise utmost caution when using the unit while children are nearby.
• Prevent the unit from being used as a toy.
• Never insert fingers, pencils, or any other items through the mesh protection of the fan.
• Never use the fan with the protective mesh removed.
• Do not expose children or ill people to direct air flow.
• Do not cover the unit.
• Do not hang anything above or in front of the unit.
• The unit may be operated in the upright position only.
• Do not use the unit near a shower, bathtub, sink, or swimming pool.
• Do not use the unit in a wet or dusty environment.
• Do not use the unit in an environment where explosive gases or flammable substances (solvents,
varnishes, adhesives, etc) are present.
• Pull the power cord out of the socket before assembly or disassembly of the unit.
• Switch the unit off and pull the plug from the socket prior to cleaning and after use of the unit.
• Keep the unit clean; prevent foreign bodies from entering the mesh openings. These could cause serious
injury, short circuit, damage or fire of the unit.
• Do not use abrasive or chemically aggressive substances to clean the unit.
VS 5023
Technical parameters
220–240 V ~ 50 Hz
< 53,77 dB(A)
40 W
EN
Double or reinforced
insulation
23