RECOMMENDED LOADS
3
• The pulsator rotates for
8 seconds to detect the
laundry load.
• Then the WATER LEVEL
and the amount of
Detergent to be used
will be shown and
water will be supplied.
4
4
4
4
Close the lid
5
• Water will be
• When the wash
supplied for 2
program ends, the
minutes after the
buzzer will ring
start of the wash to
for 10 seconds
supplement the
before the Power
water the laundry
goes off
has absorbed.
automatically.
6
6
6
6
Finish
Caution & Note
• If water is already in the tub, or
6
putting wet laundry into the tub
before starting will increase the
WATER LEVEL.
• With lightweight bulky loads,
WATER LEVEL can be set low.
• Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
(refer to page 14)
• When setting the WATER LEVEL
7
manually, do not set to Medium to
prevent damage to laundry.
• Washing with HOT water may
damage the laundry (Water is set
to cold automatically). Ensure that
the load is under 2kg.
• In order to avoid damage to
laundry,
the spin cycle may appear slow.
This also avoids wrinkles and
clothing may still contain some
water. This is normal.
• When static pressure of water is
7
more than 2kg/cm
WASH course will be within
19min.
7
7
Maximum
Load
Less than
17.0 kg
Less than
2.0 kg
, the QUICK
2
Less than
2.0 kg
Less than
17.0 kg
Less than
17.0 kg
17