Motor Protector; Thermal Protector; Vacuuming Tips; Performance Features - Sears Kenmore 116.33728 Manual Del Propietário

........... i i l.i.ii..:!.i!! .i . ............. .................... i.i; ..................................... ; . ........
Carpet edges
Guide either side or the front of the nozzle
along a baseboard. The full width agitator
brushes help remove dirt at carpet edges.
Stairs
Put handle in full upright position, Place the
carpet/bare floor selector in the bare floor
position. Use the crevice tool or combina-
tion brush. Set the On/Off switch to ON.
Note: When using attachments make
sure the cleaner is in the upright position
and the Carpet/Bare Floor selector is in
the Bare Floor position.
WARNING
Personal Injury Hazard
Do not place cleaner on stairs, If it
falls, personal injury or property dam.
age could result
Hard to Reach Areas
The slim design of the nozzle allows the
user to clean hard to reach areas such as;
under tables, chairs, couches etc...
If a lower vacuuming position is desired,
press the handle release pedal a second
time. This will allow the operator to lay the
vacuum back to a more flat position gaining
better clearance for cleaning under low
objects.
For best cleaning results, keep the airflow
passage clear.
Occasionally,check each of the areas indi-
cated for clogs. (see page 18)
!
. CAUTION
Unplug the cleaner from the outlet
before checking.
MOTOR PROTECTOR
This vacuum has a motor protector by-
pass valve which automatically opens to
provide cooling air to the motor when a
clog prevents the normal flow of air to the
motor. If the by-pass valve opens to
prevent motor overheating and possible
damage to the vacuum, you will notice a
change of sound as air rushes through the
valve opening.
Motor -_ It"
Note: Do not Protecto, lt.-_:
block motor
protector.
To correct problem: See the TROUBLE-
SHOOTING chart,
Note: The motor protector may open
when using attachments or when cleaning
new carpet, due to reduced airflow by the
attachments themselves or by new carpet
fuzz filling the dust bin quickly. See the
TROUBLESHOOTING section.
THERMAL PROTECTOR
This vacuum has a thermal protector which
automatically trips to protect the vacuum
from overheating. If a clog prevents the
normal flow of air to the motor, the thermal
protector turns the motor off automatically to
allow the motor to cool in order to prevent
possible damage to the vacuum. During this
time the headlight remains on.
To correct problem: If this occurs, turn the
vacuum off and unplug the power cord from
the outlet to allow the vacuum to cool and
the thermal protector to reset. Check for
and remove clogs, if necessary. Also
check and clean/replace any clogged
filters. Wait approximately thirty (30)
minutes and plug the vacuum in and turn
back on to see if the motor protector has
reset. The motor protector will not reset
if the vacuum is not turned off even if the
vacuum has cooled down.
10