Bimar Goya Folleto De Instrucciones página 9

Fax +32 030 9904733

positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger.
 Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity and that the electric plug is grounded. In the event of incompatibility between the
electric outlet and the plug of the heater, have the outlet replaced with another more suitable type
by professionally qualified personnel, who will make sure that the section of the wires of the outlet
is appropriate for the absorbed power of the heater (10A). In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
heater.
 Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
 Don't hang it on the wall.
 Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
 The power socket must be easy to reach so the plug can be removed quickly in case of emergency.

 Position the fan heater far from other sources of heat, inflammable
materials (curtains, carpets, etc.), inflammable gases or explosive
materials (spray cans) and from materials that can deform on exposure
to heat. Make sure that there is 120 cm of free space in front of the fan
heater and 150 cm on the sides.
 Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. (to
avoid drops of water falling on the heater or the heater falling in the water), or in places where it
could be subject to shocks.
 The support surface must be stable (exclude shelf) and not sloping (since the heater could tip over).
 Make sure that the air-intake grids and heating element are not obstructed by objects, fabrics or
anything else to avoid the heater overheating or breaking.
 In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
OPERATION
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
ATTENTION: The heater should not be used if the glass or other parts are damaged.
For the use of a chimney, operates in the following way:
1. Insert the plug into the socket.
2. Open the drawer of the controls.
3. Flame Effect is operated by pressing light switch (8) on the lens side: lens is lighting when function
is running. Flame light intensity is adjusted by turning the knob; will be greater as the knob is rotated
to the pos. maximum (clockwise).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9 24
/
Assembly page 9/24