Create WIPE PRO Manual Del Usuario página 8

Charging the battery
Charge the battery for 3 hours before its first use.
Switch the unit off before charging. Plug the charger delivered with the appliance into a
proper socket and insert the charging cable plug to the back of the appliance.
Note: The blue light indicator will flash when the appliance is charging. Once the battery is
fully charged, it will be permanently illuminated.
If you plug in the appliance while it's still on, the motor will stop and the battery will start
charging.
To maintain peak performance of the battery, it is recommended that the units is fully
discharged and then completely charged at least once a month.
Important: Prior to use, make sure that the squeegee is clean.
If the battery is low, the pilot will start flashing slowly and the appliance will switch off
after a certain time. If this is the case, charge the battery.
Cleaning without the spray bottle
Apply the detergent as usual according to the manufacturer's instructions and loosen the dirt.
Cleaning with the spray bottle and the wiper attachment
Press the spray lever on the bottle to ap-
ply the detergent and spray the surface
evenly; after that, loosen the dirt using
the wiping pad.
Note: Rinse the pad under running water
if needed.
The appliance can be switched off while the spray bottle is in use. This significantly in-
creases the operating time.
E NGL I SH
8
OPERATING INSTRUCTIONS
Switch the appliance on and the pilot will light
up. Glide the appliance from the top to the
bottom to vacuum up the detergent.
Note: Hard to reach areas can be vacu-
umed vertically or horizontally (limited
areas).