Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610004695 02-09:BM 2610004695 02-09 2/23/09 10:16 AM Page 12
B CKING
FL NGE
Hold the tool with both hands
W RNING
while starting the tool, since
torque from the motor can cause the tool to twist.
Start the tool before applying to work and let
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is under
load; this will greatly decrease the switch life.
SLIDE ON-OFF SWITCH WITH LOCK
The tool is switched "ON" by the switch
button located at the side of the motor
housing. The switch can be locked in the
"ON" position, a convenience for long
grinding operations.
TO TURN THE TOOL "ON" without locking it,
slide the switch button forward by applying
pressure ONLY at the REAR portion of the
SELECTING GRINDING WHEELS
Before using a grinding
W RNING
wheel, be certain that its
maximum safe operating speed is not
exceeded by the nameplate speed of the
grinder. Do not exceed the recommended
wheel diameter.
DISC GRINDING WHEELS
Grinding wheels should be carefully selected in
order to use the grinder most efficiently.
Wheels vary in type of abrasive, bond,
hardness, grit size and structure. The correct
type of wheel to use is determined by the job.
FIG. 7
SPINDLE
DRY
DI MOND
WHEEL
LOCK
NUT
Operating Instructions
Grinding Operations
-12-
DRY
DI MOND
WHEEL
Use only lock nut and flange
W RNING
with equal diameters.
Do not use water or other
W RNING
cooling fluid with this tool for
cutting.
button. When pressure is released the switch
button will snap to "OFF" position (Fig. 8).
TO LOCK THE SWITCH "ON", slide the
switch button forward and press "IN" the
FRONT portion.
TO UNLOCK THE SWITCH, simply press
and release the REAR portion of the button.
Switch is spring loaded and will snap back
automatically.
FIG. 8
Use disc grinding wheels for fast grinding of
structural steel, heavy weld beads, steel
casting, stainless steel and other ferrous
metals.
GRINDING TIPS
Efficient grinding is achieved by controlling the
pressure and keeping the angle between
wheel and workpiece at 10° to 15°. If the wheel
is flat, the tool is difficult to control. If the angle
is too steep, the pressure is concentrated on a
small area causing burning to the work
surface.
SPINDLE
B CKING
FL NGE
LOCK NUT
SWITCH
BUTTON
Publicidad
