Publicidad
Idiomas disponibles
Idiomas disponibles
Safety, performance, and dependability have been given
top priority in the design of your plunge router.
INTENDED USE
The plunge router is intended to be used only by adults who
have read and understood the instructions and warnings
in this manual and can be considered responsible for their
actions.
It is designed for normal and plunge routing of wood and
similar materials. It is intended to be used by a single
operator while holding both of the handles and guiding
the base of the router smoothly across the surface of the
workpiece. The workpiece should be securely clamped
should never attempt to operate the router and hold the
workpiece at the same time.
that are compatible with the 6, 8 or 12 mm collet-type bit
The plunge router can be used for:
Cutting grooves and shaping edges in wood.
Freehand cutting of letters, grooves, and patterns in
wood
Chamfering, rebating, dadoing, and dovetailing in
wood.
are given by the manufacturer of the router.
Do not use the plunge router in any way not described in
this manual.
WARNING
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result in
Save all warnings and instructions for future reference.
ROUTER SAFETY WARNINGS
Hold the power tool by insulated gripping surfaces
only, because the cutter may contact its own cord.
of the power tool "live" and could give the operator an
electric shock.
Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by your hand or against the body leaves it
unstable and may lead to loss of control.
If the product is provided for the connection of dust
connected and properly used.
Always use bits of the correct shank diameter according
to the available collet dimmension. Only use bits
manufactured according to EN 847-1. Do not use
damaged bits.
Always wear protective eye wear when operating the
router. When necessary, wear a dust mask appropriate
to the material being cut.
Keep mains lead clear from the working range of the
product. Always lead the cable away behind you.
Never reach into the area near the cutting bit when the
router is running.
Chips and splinters must not be removed while the
product is running.
Use only rotary cutting bits of the correct shank
diameter for the collet mounted.
Use only rotary cutting bits suitable for the speed of the
product.
WARNING
Always feed the product into the workpiece against
the rotational direction of the bit. Feeding in the same
rotational direction of the bit may cause the product to
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
–
–
Wear eye protection at all times.
–
Wear eye protection at all times. Wear appropriate
dust mask with suitable filters that can protect
against particles from the material being worked on.
Do not eat, drink, or smoke in the work area. Ensure
adequate ventilation.
–
The cutting bit may contact hidden wiring causing
parts of the product to become live. Always hold
the product by the designated handles and take
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
1
Publicidad
