Publicidad
Picture 31: Manual Scan Menu
5.3
Default setup
A message frame will appear, as shown in
Picture 32, asking whether the user wishes
to
reset the factory settings system. After return
installation
message will appear for the first time.
Picture 32: Default setup
VIESAN S.L : Bruno Mauricio Zabala 15,
48003 Bilbao, Spain.
ing to the factory settings, the
16
4.6
System information
The system information shows the firmware version and date, together with the receiver
and model information. See Picture 28.
Picture 28: System Information
5.
Installation
5.1
Auto Scan
The Auto Scan Menu or automatic search is shown in Picture 29. You must first select
the country using the " left" and " right" f unction keys. Next, press the " down" function
key to select " Start Scan" and press ENTER. Scanning will
between
" yes" or " no" (Picture 30).
Picture 29: Auto Scan Menu
5.2
Manual Scan
The Manual Scan Menu is shown in Picture 31. A channel scan or search can be done
establishing the following points: Country, Type of search, Start with channel,Start
with frequency... , Finish with frequency... and Wide band.
If the search type is single channel, then the country and start channel can be set. If the
search type is range of channels, then the country, start channel and finish channel can
be set.
Use the " up" and " down" function keys to select a point and the " left" and " right"
function keys to change the settings. Once you have done this, start the search (Start
Scan) and press the ENTER function key.
start after choosing
Picture 30
15
Publicidad
