Publicidad
Idiomas disponibles
Idiomas disponibles
The operation of any lawn
SAFETVG'ASSES
mower can result in foreign
objectsthrown intothe eyes,
whichcanresultinsevereeye
damage.Alwayswear safety
glasses or eye shields while operatingyour
lawn mower or performingany adjustments
or repairs.We recommenda standardsafety
glasses or wide vision safety mask worn
over spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
Engine speed was set at the factory for
optimum performance.
It is not adjustable.
ENGINE ZONE CONTROL
_k.CAUTION"
Federal regulations
require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
o Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
DRIVE CONTROL
o Self-propelling
is controlled
by holding
the operator presence control bar down
to the handle and pulling either drive
control lever rearward to the handle.
The further toward the handle a lever is
pulled, the faster the unit will travel.
o Forward motion will stop when either
the operator presence control bar or a
drive control lever are released. To stop
forward motion without stopping engine,
release a drive control lever only. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
NOTE: If after releasing the drive control
the mower will not roll backwards,
push
the mower forward slightly to disengage
drive wheels.
Operator presence control bar
rive
control
levers
handle to lift the front wheels off the
ground while turning lawn mower.
DRIVE CONTROL
ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed.
There is a turnbuckle
on the drive
control housing to increase tension on the
drive cable.
Proceed as follows:
1. Turn unit off and disconnect
spark plug
wire from spark plug.
2. Rotate turnbuckle
on drive control to
increase drive speed.
3. Operate mower to test drive speed.
Readjust as required.
4. If condition fails to improve after the
above steps (forward speed remains
the same), your drive belt is worn and
should be replaced.
Adjustment
turnbuckle
TO ADJUST
CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
o To change cutting height, pull up on
adjuster lever, move wheel up or down
to suit your requirements
and release
adjuster lever. Be sure all wheels are in
the same setting.
NOTE: Adjuster is properly positioned
when lever inserts into hole in plate.
LEVER BACKWARD
TO LOWER MOWER
Lever
LEVER
FORWARD
TO RAISE MOWER
TO ENGAGE
DRIVE CONTROL
DRIVE CONTROL
DISENGAGED
o To keep drive control engaged when
turning corners, push down on the
8
Publicidad
