Publicidad
Idiomas disponibles
Idiomas disponibles
a power failure or when the mains plug is pulled. This
prevents uncontrolled restarting.
Secure the workpiece. A workpiece clamped with
u
clamping devices or in a vice is held more secure than by
hand.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for cutting, roughing and brush-
ing metal and stone materials without the use of water.
A separate protective guard for cutting must be used when
cutting with bonded abrasives.
Sufficient dust extraction must be provided when cutting
stone.
Technical Data
Angle grinder
Article number
Rated power input
Rated speed
Max. grinding disc diameter
Grinding spindle thread
Max. thread length of grinding spindle
Weight according to EPTA-Procedure 01:2014
– with standard auxiliary handle
– with low-vibration auxiliary handle
A)
Weight (net)
Protection class
A) Measured without protective guard or auxiliary handle
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/Vibration Information
Noise emission values determined according to
EN 60745-2-3.
Bosch Power Tools
With approved abrasive tools, the power tool can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Spindle lock button
(2) On/off switch
(3) Auxiliary handle (insulated gripping surface)
(4) Grinding spindle
(5) Locking screw for protective guard
(6) Protective guard for grinding
(7) Mounting flange
a)
(8) Grinding disc
(9) Clamping nut
a)
(10) Carbide grinding head
(11) Protective guard for cutting
a)
(12) Cutting disc
a)
(13) Hand guard
a)
(14) Rubber sanding pad
a)
(15) Sanding sheet
a)
(16) Round nut
a)
(17) Cup brush
(18) Extraction guard for cutting with cutting guides
a)
(19) Diamond cutting disc
(20) Handle (insulated gripping surface)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GWS 6700
3 601 C75 ...
W
670
-1
min
12,000
mm
125
M 14
mm
kg
kg
kg
Typically the A-weighted noise level of the power tool are: 86
dB(A); sound power level 97 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
English | 9
a)
a)
a)
GWS 6700
3 601 C75 ...
670
12,000
115
M 14
17
17
1.6
1.6
1.7
1.7
1.5
1.5
/ II
/ II
1 609 92A 36V | (01.06.2021)
Publicidad
