Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGING
THE DRIVE BELT
•
Release the saw blade tension by turning the blade
tension knob on the top of band saw counterclockwise.
•
Released the belt tension by using the crank handle.
•
Using C-clip pliers (not provided) remove the retain-
ing ring from the center of the lower wheel.
•
Carefully slide the lower wheel forward and at the
same time release the saw blade from this wheel.
•
Remove the old drive belt and fit the new belt.
(ensure ribs in drive belt are seated correctly before
reassembling and tensioning the drive belt).
•
Follow procedures for CHANGING AND ADJUSTING
THE SAW BLADE & TRACKING THE SAW BLADE,
before restoring power to the band saw and setting
up for use.
13
Publicidad
