Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
- See appropriate
section
in manual unless directed
to a Sears Service Center,
PROBLEM
CAUSE
CORRECTION
Does not start
1. Dirty air filter.
1. Clean/replace air filter.
2. Out of fuel.
2. Fill fuel tank.
3.
Stale fuel.
4.
Water in fuel.
5.
Spark plug wire is
disconnected.
6.
Bad spark plug.
7.
Loose
blade or broken
blade adapter.
8.
Control
bar in released
position.
9.
Control
bar defective.
10. Fuel valve lever (if so
equipped)
is in the OFF
position.
,
4.
.
6.
7.
8.
Drain tank and refill with
fresh, clean fuel.
Drain fuel tank and
carburetor
and refill tank
with fresh gasoline.
Connect
wire to plug.
Replace
spark plug.
Tighten blade bolt or
replace
blade adapter.
Depress
control bar to
handle.
9.
Replace
control
bar.
10.Turn
fuel valve lever
to the ON position.
16
Publicidad
