Publicidad
Idiomas disponibles
Idiomas disponibles
HARDWARE CONTENTS (shown actual size)
AA
M8 x 20 mm Bolt
Qty. 8+2
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble or operate this
product. Failure to follow may result in serious injury. Save all warnings and instructions for future
reference.
WARNING
• Do not stand on, step on, or alter this unit for anything outside the designed function of usage.
• Use care when handling and assembling metal plates.
• The metal may have sharp edges or corners. The use of protective gloves is recommended.
• Always remember to use proper lifting techniques when moving the boxed or assembled unit.
CAUTION
• Do not exceed maximum load capacities listed in Product Specifications on Page 2. Evenly distribute
load on table to avoid tipping.
• Do not knock on work top which will damage the work top.
• Use only on flat, level and hard surface capable of supporting the work table and any items placed on
work table. Maintain proper footing and balance at all times.
• For indoor use only. Keep away from damp, wet or rainy conditions.
• Do not place flammable liquids on the work table unless they are secured in an approved container.
• Do not place gasoline on the unit under any circumstances.
• Assemble only according to these instructions. Improper assembly can create hazards.
• Wear ANSI-approved safety goggles and heavy duty work gloves during assembly and use.
• Keep bystanders out of the area during assembly and use.
• Do not assemble and use when tired or under the influence of drugs or medication.
• The product is not a toy. Do not allow children to play with, on or near the unit.
• Inspect before every use, do not use if parts are loose or damaged.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for replacement parts.
It is recommended that this product to be assembled on a clean, soft surface, such as a piece of
cardboard.
Estimated Assembly Time: 30 minutes (does not include unpacking time)
Tools Required for Assembly (included): 5mm Hex key wrench
Tools Required for Assembly (not included): Drill, Adjustable wrench
BB
M6 x 15 mm Bolt
Qty. 28+2
CC
M6 mm Nut
Qty. 20+2
4
Publicidad
