Publicidad
Idiomas disponibles
Idiomas disponibles
_sting Bolt
Move the workpiece against belt. Belt will follow contour.
Locking
Figure 9 -Tracking Belt
•
If the abrasive belt moves to the left, turn the bolt
counterclockwise.
If belt moves to the right, turn the
bolt clockwise.
•
Lock the position when the belt is tracking properly
so the belt will remain centered on the wheels. Hold
the position of the bolt with the 4mm hex wrench.
Tighten locking nut to secure bolt position.
ADJUSTING
BELT PLATEN
Refer to Figure 7.
WARNING:
Disconnect sander from power source
before making any adjustments.
The platen is used to properly support the workpiece
when sanding. The platen is constructed of heavy steel
to provide adequate support.
Operating with the belt platen in place will allow the
operator to sand or grind straight, even lines.
•
The platen should be adjusted so the belt does not
contact the platen until work is fed into the belt.
•
To adjust belt platen, loosen and remove knobs to
remove belt cover.
•
Loosen socket head bolts and adjust belt platen
position.
•
Tighten bolts and secure platen.
•
Replace belt cover and tighten knobs.
ABRASIVE
BELT FINISHING
•
The abrasive belts can be used to sand wood,
deburr metal, or polish plastic.
•
The belt are most efficient when used with the table.
The 2" belt size is convenient for getting into corners
and concave curved edges. The 1" belt size is
convenient for getting into tight spots.
CONTOUR
SANDING
Refer to Figures 7 and 10.
•
Belt platen can be removed for contour sanding.
•
Remove knobs and belt cover.
•
Remove socket head bolt and washers holding
platen to belt housing. Remove belt platen.
•
Replace belt cover and knobs.
Figure 10 - Contour Sanding
SHARPENING
Refer to Figure 11.
•
Adjust belt table to desired sharpening angle and
tighten securely. Use belt sander to notch the back
of an auxiliary piece of wood.
•
Using a C-clamp, attach auxiliary piece of wood to table.
It acts as a support while sharpening.
•
Top edge of wood should be less than 1/161' from
abrasive belt.
Figure 11 - Sharpening
HORIZONTAL
BELT SANDING
Refer to Figures 12 and 13, page 8.
WARNING:
Disconnect sander from power source
before making any adjustments.
•
The belt housing can be tilted to a horizontal
position.
•
Remove the belt table by removing the socket head
bolt and flat washer.
•
Loosen the housing lock bolt, tilt the belt housing to
the horizontal position, and tighten the bolt to secure
the housing position.
•
The drive wheel of the belt can be used as a contact
wheel for sanding curved surfaces.
Belt Housing
Flat Washer
/
S°Ckdetolt_
_
"
Housing Lock Bolt
Figure 12 - Adjusting Belt Housing
Publicidad
