Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly
I
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
This new product
has been shipped
in a partially
assembled
condition
as described
below.
Carefully
check
the
packing
list below
to ensure
all items are included in the package;
the packing
list describes
all loose
items that
are not assembled
to the product
as shipped.
Do not operate
the product
if any packing
list
items are already
assembled
to your
product
when you unpack
it. Call the customer
service
number
below
for assistance.
Operation
of a
product
that may have
been improperly preas o
sembled
could
result in serious
personal
injury.
m
Inspect
the product
carefully
to make sure
no
breakage
or damage
occurred
during
shipping.
m Do not discard the packing material until you have care -
fully inspected and satisfactorily operated the product.
m If any parts are damaged
or missing,
please
call
!-888-266-7096
for assistance.
PACKING
LIST
Electric blower
Blower tube
Mulcher tubes
Bag
Operator's
Manual
,&
WARNING:
If any parts are damaged or missing, do
not operate this product until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with
this product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING:
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
ASSEMBLE
AS A MULCHER
See Figure 3, page i.
Inserting the mulcher tube converts the unit from the blowing
to the vacuuming function.
!. Remove blower tube if assembled to unit.
2. Slide the front and rear mulcher tubes together until the
lock button engages. (See Fig 3)
3. Pull the lock button forward to disengage the gate. Hold
the gate open. (See Fig 3.1)
4. Insert the "wedged" end clip of the mulcher tube into
the rear clip. (See Fig 3.2). Push the "hooked" end clip of
the mulcher tube into the front clip. (See Fig 3.3). Press
the lock button back to engage the mulcher tube. (See Fig
3.4)
5. To remove tubes, reverse the actions of the previous
3 steps.
6. Insert the bag adaptor into the blower outlet. Lock the
bag adaptor with the lock button. To remove the bag,
simply press lock button and remove bag. (see Fig.5).
NOTE:
It may be necessary to remove the blower tube or
mulcher tubes to clear a blocked tube or impeller.
A
WARNING:
To prevent serious personal injury,
make sure the switch is in the OFF position, it is
unplugged, and the impellers have stopped before
attaching or removing tubes.
ASSEMBLE
AS A BLOWER
See Figure 4, page ii.
!. Remove mulcher tube if assembled to unit.
2. Slide blower tube forward until the notched areas on
the blower housing click into the slots on the tube.
3. Insert the concentrator nozzle onto the regular nozzle
to lock. (Concentrator nozzle is used to increase air flow
in tight areas: flower beds. under decks, etc.).
NOTE: Blower will not run until gate is closed and locked.
INSTALLING
BAG WITH SHOULDER
HAR=
NESS
See Figure 5, page i.
While standing in the operating position adjust the length
to fit the operator's size. Pull the tab to lengthen, pull the
strap to shorten.
9 - English
Publicidad
