Troy-Bilt 01924 Manual Del Propietário página 14

Storage
Data tag information is very important if you need help from
our Customer Service Department or an authorized service
dealer.
The data tag (Figure 9) is located on the engine support on
the muffler side of the generator_ For future reference, please
copy the model, revision, and serial number of the generator
in the space below.
MODEL
REV NO "_
SERIAL
AC VOLTS ]
ACAMPS ]
AC WATTS ]
DC VOLTS ]
DCAMPS [ ]
Single Phase / 60 Hz/ 3600 RPM
Rated at 40 C / Class F Insulation
Troy_Bilt@ is a registered trademark of
MTD and is used under license to
Bnggs & Stratton
Power Products Group, LLC
Jefferson, Wl 888-611-6708
Copy Revision
Here
Copy Serial
Number Here
The generator should be started at least once every seven
days and allowed to run at Heas[ 30 minutes. If this cannot
be done and you must store the unit for more than 30 days,
use the following guidelines to prepare it for storage.
Generator Storage
° Clean the generator as oudined in "Generator Cleaning'.
, Check that cooling air slots and openings on generator
are open and unobstructed.
WARNING
DO NOT place a storage cover over a hot generator.
Let equipment cool for" a sufficient time before placing the
cover on the equipment.
Engine Storage
See engine owner's manual for instructions.
Other Storage Tips
° To prevent gum from forming in fuel system or on
essential carburetor parts, add fuel stabilizer into fuel
tank and fill with fresh fuel. Run the unit for several
minutes to circulate the additive through the carburetor.
The unit and fuel can then be stored for up to
24 months. Fuel stabilizer can be purchased locally.
° DO NOT store fuel from one season to another unless
it has been treated as described above.
° Replace fuel container if it starts to rust. Rust and/or dirt
in fuel can cause problems if it's used with this unit.
, Store unit in a clean and dry area.