Publicidad
Idiomas disponibles
Idiomas disponibles
Depth stop (Picture A)
•
Release the auxiliary handle (3) and insert the depth stop.
•
Set any drilling depth as a difference between the point of drill tip and point of depth stop.
•
Press the adjuster to keep the depth setting.
•
Secure the depth stop by tightening the handle clockwise.
Information on the drill bits
The machine is designed for using replacement drill bits with cylindrical shaft, with diameter from 1,5
to 13 mm. Bits with ¼" (6,35 mm) hex shank can also be used. Always use a drill suitable for the
material being worked.
Warning! Risk of injury! When replacing the drill bit, wear protective gloves.
The drill bit and chuck may become hot during use, especially when impact
drilling.
Drill bit clamping (Picture B)
•
Loosen the chuck by turning the front part in the direction of the arrow unlock. The chuck jaws
open.
•
Place the tool in the jaw and tighten the chuck evenly by turning its front part in the direction of
the arow lock (installation of the tool without using the chuck key). Tighten the chuck firmly and
make sure the drill is in the middle of the jaw.
Note: Before drilling, make a short test to see if the drill bit is centered and straight. Do not use bent
or damaged drill bits and discard them.
OPERATION
•
Wear protective gloves.
•
Wear protective goggles. Flying shavings can cause injury.
•
Wear hearing protection for protection from continuous noise in the workplace.
•
Wear dust mask for protection from airborne dust.
Check whether the type of the plug corresponds with the type of the socket.
The data on the nameplate must correspond with the actual power supply voltage.
Warning! Risk of injury! Make sure that the On/Off switch (9) is not pressed down
or locked by the setting button (5). Pay attention when working that the air vents
are not covered up or congested.
Switching on
Press the switch (9) and hold it. The rotation speed depends on the pressure and the actual speed
limiter (10) position – light pressure means lower speed; further pressure means higher speed.
Switching off
Release the switch (9).
Wear personal protective equipment
EN - 25
Publicidad
