MTF PV 800EB Manual Del Usuario página 27

The power tool is almost maintenance-free
• Keep the power tool and the air vents clean and unplugged.
• Make sure that no moisture reaches the inside of the power tool during cleaning.
• Service repair consists of replacing worn carbon brushes only (contact your seller or a qualified
electrician).
Cleaning
• Clean the power tool after every use.
• Clean the power tool with a wet cloth. Do not use cleaning agents or solutions; these can
corrode the plastic parts of the power tool.
Storage
• Keep the power tool in a dry and safe place out of reach of children. Remove the tool or adapter
from the chuck.
• We recommend using the original packaging for its storage.
• Wait until the power tool cool down completely before storing.
TROUBLESHOOTING
Problem
Drill does not work
Vibrations are too strong
Motor overheated
If you are unable to repair the defect, take the product to the manufacturer's authorized servicing
facility for repairs.
TECHNICAL DATA
Impact drill MTF PV 800EB
Rated voltage
Frequency
Input power
No load speed
Impact rate
Chuck clamping range
Max. drilling diameter, concrete
Max. drilling diameter, steel
Max. drilling diameter, wood
Weight
Protection class
Possible cause
Mains socket is not live
Power cable fault
Drill or tool not mounted
correctly
Overload due to excessive
pressure to drilling
Air vents blocked
Worn carbon brushes
220-240 V
50 Hz
800 W
0-3000/min
0-48000/bpm
1,5-13 mm
13 mm
13 mm
25 mm
1,8 kg
II
EN - 27
Solution
Check mains socket and/or circuit
breaker/RCD
Check whether power cable is
disconnected or damaged
Check and mount the drill or tool
correctly
Allow the motor to cool down by
running the tool idle at maximum
speed for 3 minutes
Clean air vents
Provide carbon brushes exchange