Turning Off The Machine; Maintenance; Safety Rules; Cleaning The Machine - Bezzera BB005 Manual De Instrucciones

MOD. BEZZERA BB005
To stop grinding, just release the switch (Fig. 01;
pos. 11).
Automatic version
1) Press the main switch (Fig. 01; pos. 4) (the
switch light is on).
2) Rotate the dosing adjustment knob (Fig. 01;
pos. 12) selecting the desired dose.
3) Position the filter holder with 1 or 2-dose filter
on the bracket (Fig. 01; pos. 3).
4) Push the filter holder holding the switch pressed
(Fig. 01; pos. 11) until you obtain the desired
dose (Fig. 05).
5) Exert a light pressure on the coffee contained
in the filter holder using the specific presser
(Fig. 01; pos. 1)
Attention: once the switch is pressed
(Fig. 01; pos. 11) the machine keeps
grinding the coffee for the preset time.
To stop grinding it is not enough to release the
switch (Fig. 01; pos. 11), it is necessary to rotate
the dosing adjustment knob (Fig. 01; pos. 12) to
position "0" or to switch off the machine pressing
the main switch (Fig. 01; pos. 4) (the switch light
is off).

5.5 Turning off the machine

Turn off the grinder if there is
no more coffee inside the hop-
per, to avoid motor operation
without load and ensuing over-
heating (at 100°C the thermal safety of
the motor trips; it automatically resets
when the temperature decreases).
Press the main switch (Fig. 01; pos. 4) (the switch
light is off).
If the machine is not used for a long time:
1) Detach the plug from the grid socket.
2) Empty the hopper.
3) Store the machine in a dry environment, pro-
tected from bad weather

6 - MAINTENANCE

To allow the machine to work correctly, follow the
maintenance instructions provided below.

6.1 Safety rules

BB005TM
lever to the resting position 0. Remove the plug
and close the water interception tap before carrying
out maintenance and/or cleaning work. If the
machine is malfunctioning, do not attempt to
repair it alone and call the technical assistance
service immediately. If the electrical power cable
has been damaged, turn off the machine
immediately, turn off the water and call the
technical assistance service. Do not replace it
alone. Carry out cleaning/maintenance when the
machine is cold, preferably wearing protective
gloves.

6.2 Cleaning the machine

These recommendations are indicative.
Maintenance and cleaning frequency depends on
machine use.
1) Clean the tray.
2) Clean the machine body.
neutral detergents, carefully drying surfaces before
reconnecting the machine to the power supply.
6.3 Correct product disposal (electrical
and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection
systems).
life cycle. To avoid any damage to the environment
or to health, caused by unsuitable waste disposal,
the user is asked to separate this product from
other types of waste and to recycle it responsibly to
help the sustainable recycling of material
resources.
Domestic users are invited to contact the dealer
24
Do not subject the machine to water
jets. Disconnect the machine from the
electrical power by turning the electrical
power network omnipolar knife-switch
Daily
Do not use solvents, detergents or
abrasive sponges for washing and
cleaning. Clean the machine body with
a cloth dampened in water and/or
The sign carried on the product or on its
documentation indicates
product must not be disposed of with
other domestic waste at the end of its
that the