KRESS MISSION KR233 Instrucciones De Usuario página 16

Troubleshooting
If your Mission RTK
TM
contact your dealer.
Symptom
The LED light on the charging
base does not turn on.
Mission RTK cannot
TM n
correctly dock with the
charging base.
Machine runs out of power but
does not return to charging
base.
When Mission RTK
TM
downhill, it overruns the
boundary line.
After Mission RTK
TM
on, the start button is pressed,
but Mission RTK
TM
16
work.
EN
Mission RTK does not give
TM n
an alarm when it is outside the
Geo fence.
Mission RTK is parked in
TM n
the middle of the obstacle.
Unable to read log.
Mission RTK is parked
TM n
around the wall and cannot be
started, and the positioning
light is always on red.
does not work correctly, follow the trouble shooting guide below. If the fault persists,
n
There is no power.
The magnetic strip is placed in
the wrong direction.
No virtual charging base is
mapped.
The length of the magnetic strip
is less than 8.2' (2.5 m).
is going
n
The angle of the border line is
very sharp.
Mission
TM
is turned
n
working area.
does not
n
Poor positioning signal
The software of Mission
itself is not the latest.
Mission
TM
The obstacles around Mission
RTK are relatively small, and
n
Mission
TM
of trouble.
The sensor of Mission
abnormal
The format of U-disk is not
FAT32.
Mission
TM
shaded area for too long,
triggering the safety protection.
There are too many walls or
trees in the area, blocking the
positioning signal.
Cause
RTK is outside the
n
RTK
TM n
RTK is powered off.
n
TM
RTK fails to get out
n
RTK is
TM n
RTK works in the
n
Solution
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Check if the magnetic strip is placed
in the wrong direction. When correctly
placed, the green stripe of the magnetic
strip is facing away from the charging
base.
Rebuild the map and add the virtual
charging base.
The length of the magnetic strip should
be guaranteed to be greater than 8.2'
(2.5 m).
Try to avoid layout scenarios with sharp
angles.
Move Mission RTK inside the working
TM n
area.
Find an open place, wait for the
positioning signal light to turn green,
and then press start button.
Update the software of the Mission
RTK .
n
Turn Mission RTK on.
TM n
Set the area where Mission
easily trapped as No-Go.
Detect Mission RTK 's diagnostic
TM n
page on the APP and check the sensor
status.
Convert the format of U-disk to FAT32.
Try to avoid letting Mission
in areas with too much shade.
TM
RTK is
TM n
RTK mow
TM n