Descargar Imprimir esta página

Keba KeContact T10 Instrucciones Breves página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
!
ATTENTION
Possible damage to property!
 Never clean the device with aggressive solvents and cleaning agents, abrasive materials, spray water (garden
hose, high-pressure cleaner, etc.) or excessive pressure.
When installing the device, the following additional notes must be observed:
 During outdoor installation, the connection panel cover must not be opened in unsuitable weather (rain, wind,
snow, etc.).
 The device must be mounted on the wall vertically, without any tilt, on a completely flat wall or floor-mounted
column; the back side of the charging station must be completely protected.
 The mounting holes may be drilled only by an authorized specialist in compliance with the safety regulations.
The supply line must not be damaged during this process.
 When connecting and wiring the device, ensure that the connection area is clean so that no foreign objects
(pieces of wire, etc.) get inside the device.
 The joints between the wall/floor-mounted column and the device must not be sealed with silicone. Water must
be able to drain off behind the device.
 The device must not be used as a climbing aid.
General criteria for the site selection
 Observe the permissible ambient conditions (see "Technical data" in the operating manual).
 Take into account the local electrical installation regulations, fire prevention measures and accident prevention
regulations as well as emergency routes at this site.
 The device must not be installed in zones at potential risk of explosion (EX environment); areas with special
hazards (flooding, mudslides, avalanches, etc.) must be avoided.
 Do not install the device in the immediate vicinity of flammable materials.
 The device may only be installed in stationary applications.
 Install the device so that it is not in the direct path of people.
 Do not install the device at locations where it is exposed to ammonia or ammonia gas (e.g. in or at stables).
 The mounting surface must be sufficiently stable in order to withstand the mechanical forces.
 Do not install the device at locations where falling objects could damage the device (e.g. hung-up ladders or
automobile tires).
 The device must not be exposed to direct spray water (e.g. neighboring manual car wash facility, high-pressure
cleaner, garden hose).
 If possible, the device should be installed with protection from direct rain and sunlight.
 Follow the applicable national installation standards and regulations.
Disposal
ATTENTION!
Please observe the regulations regarding disposal of electric appliances and electronic devices.
EN
2

Publicidad

loading