Braun BC20 Instrucciones Para El Usuario página 3

Setting the clock display brightness
The clock will automatically adjust the display brightness de-
pending on the surrounding level of light.
1. In a well-lit environment, slide the ALARM / TIME / BRIGHTNESS
switch to the BRIGHTNESS position.
2. Press the '+' or '-' key to set the desired brightness.
3. In a dark environment (or by covering the sensor), slide the
ALARM / TIME / BRIGHTNESS switch to the BRIGHTNESS position.
4. Press the '+' or '-' key to set the desired brightness.
Setting the year, date and month
1. Press the DATE button.
2. Press the '+' or '-' key to set the current year. Press and hold the
'+' or '-' key to speed up the setting. Press the DATE button to save
the setting.
3. Press the '+' or '-' key to set the current month. Press and hold
the '+' or '-' key to speed up the setting. Press the DATE button to
save the setting.
4. Press the '+' or '-' key to set the current date. Press and hold the
'+' or '-' key to speed up the setting. Press the DATE button to save
the setting.
Using the alarm and snooze function
1. Enable the alarm by touching the ALARM ON / OFF button for ~
1 second. The green light will light up and the bell icon will appear
on the LCD display.
2. Touch the SNOOZE key to stop the alarm and activate the
snooze function. When the alarm sounds, the alarm icon will flash.
3. To disable the alarm and snooze function, touch the ALARM ON
/ OFF button for ~ 2 seconds. The green light will go out and the
bell icon will disappear.
Note: When the snooze function is activated, the alarm will auto-
matically start again after 5 minutes. The snooze function will not
stop unless you press the ALARM ON/OFF button to turn off the
snooze.
Using the USB-C ports
Plug a compatible device into either of the two USB-C ports for
charging.
Please make sure that any connected device is rated at the same
level as the output of the ports: DC 5.0V
Battery replacement
1. If the AC/DC adapter is removed from the clock and the current
time is not memorised after plugging in again, then the button
cell battery must be replaced immediately.
2. It is recommended to replace the button cell battery once a
year.
Guarantee
2 year guarantee against material and workmanship defects
(except battery). The guarantee is valid in those countries where
the clock is officially being sold.
Broken or cracked lens screens are not covered under the
Guarantee.
Braun helpline
Should you have a problem with your product, please check your
local service centre at:
www.braun-clocks.com
www.braun-watches.com
or contact +44 808 175 3235 (calls free within the UK)
or +44 208 208 1833.
WARNING! This product is covered by the Waste Electrical and
Electronic Equipment (WEEE) Directive and the battery used
in this item is covered by the Battery Directive. It should not be
discarded with normal household waste but taken to your local
collection centre for recycling.
This product conforms to the EMC requirements as per council
directive 2014/30/EU.
Certain trademarks used under license from the Procter & Gam-
ble Company or its affiliates.
2.0A / 1.0 A.