JCM Technologies RC3 TLC868 Manual De Usuario página 6

User's Manual
Introduction
The system is designed for applications in pedestrian doors. Is a position detection system of the pedestrian door status. Is a
wireless system composed by one transmitter and one receiver. The receiver monitors the status of transmitters connected to it.
Technical data
Frequency
Operating consumption
Radiated power
Watertighness
Size
Range
Battery life (aprox)
Starting up
Mechanical installation
Install the transmitter following the installation steps and tips below.
Install the two parts of the transmitter, one in front of the other, as shown in figure below. Avoid placing metal surfaces between the
receiver and transmitter.
SWIPE TO OPEN COVER REMOVE PLASTIC
Programming the transmitter on the receiver
While programming the receiver, press the PROG button on the transmitter to be programmed into the receiver.
The receiver allows programming 6 transmitters (3 for Relay 1 and 3 for Relay 2).
Each safety edge transmitter must be learnt into the appropriate channel of the safety edge receiver.
Mode Configuration of transmitter programming in the receiver.
1 When you open the pedestrian door, relay 1 on the receiver will be activated
2 When you open the pedestrian door, relay 2 on the receiver will be activated
3 When you open the pedestrian door, the two relays will be activated at the same time
UM_3200216_RC3-TLC868_3ID_Rev02
Multifrequency system 868MHz auto-adjustable
12mA
< 25mW
IP42
40 x 194,5 x 20mm
50m
2 años
INSTALL THE TWO PARTS DRILL DOOR SWIPE TO CLOSE COVER
Led R1
ON
OFF
ON
EN
Led R2
OFF
ON
ON
Page 6/8