JCM Technologies RC3 TLC868 Manual De Usuario página 7

PRESS RPORG BUTTON
PRESS RPROG BUTTON
Maintenance
Beeps and leds error indication table
Equipment Error
RB3 R868 RC3 TLC868 low battery
RB3 R868 Communication error between Receiver and Transmitter
Replacing the transmitter battery
Remove the box cover. Replace the two used batteries with new ones, taking into account the polarity indicated by the connector.
Check that the new batteries support the same temperature range as those they are replacing.
Use of the system
This equipment is designed for applications in pedestrian doors. It is not guaranteed for directly activating equipment other than that
specified.
The manufacturer reserves the right to change the specification of the equipment without prior warning.
Important annex
Disconnect the power supply whenever you proceed to the installation or repair of the control panel.
In accordance with the European low voltage directive, you are informed of the following requirements:
- For permanently connected equipment, an easily accessible connection device must be incorporated into the cabling.
- This system must only be installed by a qualified person that has experience and knowledge of the relevant EU standards.
- The instructions for use of this equipment must always remain in the possession of the user.
- The frequency of the RContact system does not interfere in any way with the 868 MHz remote control systems.
UM_3200216_RC3-TLC868_3ID_Rev02
LED TURNS ON
LED TURNS OFF & END PROG
PRESS TRANSMITTER PROG ONE BEEP & PROGRAMMED
Beeps
4 beeps each 20 seconds
No beeps
Leds
OFF
ON
Page 7/8