Publicidad
5. Maintenance
5.1 Cleaning
- Be sure to unplug the device properly by holding the plug and
removing it from the USB outlet.
- Clean the device surface with a clean soft cloth dampened with clean
tap water or distilled water after each use.
- Immediately dry the surface with a clean dry soft cloth any time it
comes into contact with moisture, chemicals, or water.
- Always keep the device clean. Store the device in a clean and dry
place.
Note:
* NEVER clean the device or any of its parts with running water and
* NEVER operate or charge the device if you suspect that water is inside
the device or if water on any surface of the device.
* DO NOT open or dismantle the device, as there are no user
serviceable parts inside.
* Take care to not allow the device to be subjected to any pressure,
other than only what is needed to use, charge, and clean the device.
Excessive force may damage or weaken the bulb and other
components.
* DO NOT use alcohol or volatile organic solvents (for example, paint
thinner or nail polish remover) to clean the unit, as these substances
can weaken and/or permanently damage the device's components.
5.2 Storage
Store the device and all its parts in a cool dry place.
Storage condition:
Temperature: -25°C to 45°C/-13°F to 113°F
Relative humidity: ≤ 75%
Note:
* Do not place or store the device where it can fall or be pushed into a tub,
sink or any other vessel containing water.
* KEEP the device away from heated surface.
*Do not store in a lint or dusty area. Avoid direct sunlight. This may damage
the device.
14
Publicidad
