Genesis GBG600L Manual Del Operario página 7

• Do not stand directly in front of the machine when turning it "ON".
Always stand off to the side of the machine and do not allow any part of your body to be in line
with the path of the wheel.
• Never grind on a cold wheel.
run at idle speed for on full minute before applying work to the grinding wheel.
• Never grind on the side of the wheel.
• Never apply coolant directly to the grinding wheel.
the bonding strength of the wheel causing it to fail. Dip the hot work piece into water to cool it.
• Never start the grinder
other attachments (wire brushes, buffing wheels, etc.)
• Always ease the work piece against the wheel
light pressure when applying the work piece to the grinding wheel. excessive pressure can
cause the wheel to crack or overload the motor.
• Avoid awkward operations and hand positions
sudden slip that could cause your hand or fingers to move into the grinding wheel, wire brush,
buffing wheel, etc.
• Always keep hands and fingers away from rotating attachments.
• Always hold the work piece firmly against the tool rest.
rest is securely tightened in place to prevent movement during use.
• Do not grind magnesium or aluminum,
• Grinding creates hazardous sparks, never operate the grinder
flammable gas, liquids, or in an explosive atmosphere.
• Dress the grinding wheel face only.
become too thin for safe use.
• If any part of the grinder is missing, damaged or fails in any way,
or should any electrical component fail to perform properly, shut off the switch. Remove the
machine plug from the power source and have damaged, missing, or failed parts replaced
before resuming operation.
• Clean the grinding dust from beneath the grinder frequently
• Do not operate in rain or in damp locations.
• Grounding required.
SAVE THESE INSTRUCTIONS
The grinder should always be started and allowed to
Always grind on the face of the wheel only.
with the work piece pressed against the grinding wheel or
fire may result.
Dressing the wheel sides can cause it to
Coolant may weaken
when starting to grind. use
where an unexpected or
Be sure the tool
near
7