Publicidad
Idiomas disponibles
Idiomas disponibles
14) Reinstall freezer shelf in lower position. Set ice container (2) on shelf.
15) Locate factory punched holes at bottom right corner of rear panel. Holes are drilled through
��f cabinet liner. Align water valve bracket with factory drilled holes. Use a power drill with a
Phillips ® head bit to drive the two self drilling screws (4) through bracket and into cabinet.
16) Connect wiring harness to water valve. Make sure connection is tight.
17) Push plastic water supply tubing into bottom of water valve as far as it will go. Finger tighten
nylon compression nut onto threaded end of water valve. Tighten another one half turn
with wrench. DO NOT over tighten.
��� ������ ������� ����� ������ �� ���� �� ������� ���� ��� ������� ������ ���� F)��：����� ����
�� ������� ���� � ���������� ��������� �������� ������� �� ������� ������ �������� �������
11
Publicidad
