Publicidad
Idiomas disponibles
Idiomas disponibles
2.9
Unplug the refrigerator. To eliminate the danger of electric shock during
unplug the refrigerator from its electrical outlet.
IMPORTANT: Ensure that your water supply line connec ons comply with all local plumbing��des.
Before Installing �he Water Supply Line, You Will Need
Basic tools: adjustable wrenc
Access to a household cold water line with water pressure between 20 and 120 psi.
A water supply line made of 1/4 inch (6.4 mm) OD, copper tubing. To determine the length of copper
tubing needed, you will need to measure the distance from the ice maker inlet valve at the back of the
refrigerator to your cold water pipe. Then add approximately 7 feet (2.1 meters), so the refrigerator can be
moved out for cleaning.
A shuto valve to connect the water supply line to your household water system. DO NOT use a self-
piercing type shuto valve.
A compression nut and ferrule (sleeve) for connec ng the water supply line to the ice maker inlet valve.
NOTE: Water line kit number 5303917950, available from your appliance dealer at add onal cost, contains 25
compression nuts, (2) ferrules/sleeves, and instru ons for installing a water supply line.
To Connect Water Supply Line To Ice Maker Inlet Valve
1. Disconnect refrigerator from electric power supply.
2. Place end of water supply line into sink or bucket. Turn ON water supply and ush supply line un l water
is clear. Turn OFF water supply at shuto valve.
3. Unscrew plas c cap from water valve inlet and discard cap.
4. Slide brass compression nut, then ferrule (sleeve), onto water supply line, as shown.
5. Push water supply line into water valve inlet as far as it will go (1/4 inch). Slide ferrule (sleeve) into valve
inlet and finger tighten compression nut onto valve. Tighten another half turn with a wrench; DO NOT over
tighten.
6. With steel clamp and screw, secure water supply line to rear panel of refrigerator as shown.
7. Coil excess water supply line (about 2-1/2 turns) behind refrigerator as shown and arrange coils so they
do not vibrate or wear against any other surface.
8. Turn ON water supply at shutoff valve and tighten any connections that leak g�� �f����f�� ���f�.
9. To turn ice maker on, lower wire signal arm. (See ice maker front cover for on/off position of arm.
I���RTA�T: I� ����g ���fP�������� i� 4Pefg �Pf �4� ��� ����f �P ����� �fP�e���� ���. A�f �� ��� ��e�����
����g ��� ��eg� ��� ����f �P ����� i Pf � ����g ���Pf� ������ � �e�� �f�� P� ���. ��� ��e����� ��� ��eg�
��� �P �� ��g�P�Pf�� Pf 4��� �PPf ����Pf. D�g��f� ��� ���� �ef��� �4� ��fg� i� 4Pefg.
Connec ng Ice Maker to Water Supply
at blade screwdriver, and Phillips
screwdriver.
TM
12
you must
Publicidad
