Publicidad
Idiomas disponibles
Idiomas disponibles
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press one of the function
buttons
to select
a
source.
Press TIMER to display @ and U PLAY.
When using the remote control, press TIMER while pressing
SHIFT.
Time and audio source name flash alternately.
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or II.
Turning MULTI JOG changes both the hour and the minute.
+
or -
is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated
period.
The duration can be set between 5 and 240 minutes in 5-
minute steps.
+
or -
is also available instead of MULTI JOG.
5
6
7
8
Adjust the volume.
The source sound will play at the volume level set in this step
when the power is turned cm by the timer.
If the volume level is set to 21 or higher, however, it will
automatically be set to 20 when the power is turned on.
Prepare the source.
To
listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune into a station.
Press POWER to turn off the power.
@
remains on the display after the power is turned off (timer
standby mode) if the power-economizing
mode is OFF.
Get ready for the TAPE function
or the timer
recording.
To
listen to the tape, press > on Deck 1 or 2.
To record the source, insert the tape into Deck 1 and press
on Deck 1.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
You can change the source that was selected in step 1 by
pressing one of the function buttons before pressing ENTER
or II in step 3.
. If the power-economizing
mode is ON, 0 is not displayed in
the timer standby mode.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the
timer recording period,
on deck 1 is released before the timer
is off.
When the tape length is longer than the timer recording period,
is not released. if
is not released for a long time, the tape
in the deck may be damaged. Press WA
to release
.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or I I is pressed within 4 seconds after
step 4.
ENGLISH
19
Publicidad
