Schluter LIPROTEC-PEBZS Instrucciones Breves página 29

LIPROTEC
Fastening the wall bracket with adhesive strips
1. Clean the surface to which you wish to attach the wall
bracket and clean the back of the bracket.
2. Remove the protective film from one side of one of the ad-
hesive pads.
3. Stick the first adhesive pad to the back of the wall bracket,
centrally above one of the two holes.
4. Remove the protective film from one side of the second
adhesive pad.
5. Stick the second adhesive pad to the back of the wall
bracket, centrally above the other hole.
6. Remove the second protective film from both adhesive
strips.
7. Stick the wall bracket to the wall with the arrow pointing
upwards. Press it against the wall for a few seconds.
8. Cover the screw holes with the self-adhesive caps provided.
> The wall bracket is now attached to the wall.
Fastening the wall bracket with screws
1. Make sure that the section of the wall you wish to attach
the bracket to is flat and suitable for a drilling depth of
40 mm.
2. Mark the locations of the drilled holes, one above the other
and 95 mm apart.
3. Use a 5-mm drill bit to drill holes at the marked locations
(drilling depth: 40 mm).
4. Push the wall plugs provided into the drilled holes.
5. Press the wall bracket against the wall with the arrow
pointing upwards and screw in the screws provided.
EN
29