Publicidad
Idiomas disponibles
Idiomas disponibles
16
Before starting work, check the work area and remove foreign objects that could cause injury or damage the
equipment.
Operate the tool only during daylight hours or in good lighting conditions.
Be careful and use common sense at all times when operating the saw. If an abnormal situation occurs, shut
off the chainsaw immediately and contact an authorized service center.
Starting the engine
1. Make good pillar and lay the chainsaw on the ground so that the chain does not touch anything.
2. Hold the front handle with one hand and take the chainsaw to the ground. Hold the rear handle
by stepping on it.
3. Set the ignition switch to the "on" position.
4. Press the primer about 4-5 times until fuel appears in the primer.
5. Pull the air damper lever toward you until it locks, the air damper will close.
6. Slowly pull the starter grip until you feel resistance, then pull the cable with a steady and steady movement
to a distance of no more than 50-60 cm. Repeat the procedure several times until the engine starts.
7. Press the throttle lock key and the throttle key, the carburettor air damper will open automatically, the
damper lever will return to its original position.
WARNING!
Do not allow the cable to be pulled all the way out before the starter reel has stopped. This will
cause the starter motor to break and is not covered by the warranty.
Stop the engine
1. Release the throttle lock key and throttle key to allow the engine to idle.
2. To stop the engine, move the switch to the "off" position.
NOTE: To stop the engine in an emergency, engage the chain brake and move the switch to the "off" position.
Clipping
Small trees up to 15 cm in diameter are usually cut off with a single cut. On larger trees, a pre-cut must
be made. The notch determines the direction in which the tree will fell.
WARNING!
Mark out your escape path (A) in advance and clear it of possible obstacles before you start
cutting. The escape path must be in the direction opposite to the direction in which the tree
is expected to fell (B) (fig. 14).
OPERATING PROCEDURE
B
A
Fig. 14
GASOLINE CHAIN SAW
Publicidad
