Craftsman 900.277300 Manual De Instrucciones página 2

Full one year warranty on Craftsman Industrial Plate Joiner
If this Craftsman Industrial Plate Joiner fails due to a defect in material or workmanship
within one year from the date of purchase Sears will repair it free of charge.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY RETURNING THE TOOL TO THE
NEAREST STORE OR SERVICE CENTER IN THE UNITED STATES.
This warranty gives you specific legal rights and you may have other rights which vary
from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: When using electric tools,
basic safety precautions should always be
followed to reduce risk of fire, electric
shock, and personal injury, including
the following:
READ ALL INSTRUCTIONS
DOUBLE INSULATION
Double insulated tools are constructed
throughout with two separate layers of
electrical insulation or one double
thickness of insulation between you and
the tool's electrical system. Tools built with
this insulation system are not intended to
be grounded. As a result, your tool is
equipped with a two prong plug which
permits you to use extension cords
without concern for maintaining a
ground connection.
NOTE: Double insulation does not take the
place of normal safety precautions when
operating this tool. The insulation system
is for added protection against injury
resulting from a possible electrical
insulation failure within the tool.
CAUTION: WHEN SERVICING USE
ONLY IDENTICAL REPLACEMENT
PARTS. Repair or replace damaged cords.
POLARIZEDPLUGS
Polarized plugs (one blade is wider than
the other) are used on equipment to
reduce the risk of electric shock. When
provided, this plug will fit into a polarized
outlet only one way. If the plug does not fit
fully into the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician to install the proper outlet. Do
not change the plug in any way.
SAFETY INSTRUCTIONS
FOR ALL TOOLS
• KEEP WORK AREA CLEAN.
Cluttered areas and benches
invite injuries.
• CONSIDER WORK AREA
ENVIRONMENT. Don't expose
power tools to rain. Don't use power
tools in damp or wet locations.
Keep work area well lit. Do not use
tool in presence of flammable
liquids or gases.
• GUARD AGAINST ELECTRIC
SHOCK. Prevent body contact with
grounded surfaces. For example;
pipes, radiators, ranges, and
refrigerator enclosures.
• KEEP CHILDREN AWAY. Do not
let visitors contact tool or extension
cord. All visitors should be kept
away from work area.
• STORE IDLE TOOLS. When not in
use, tools should be stored in dry,
and high or locked-up place - out of
reach of children.
• DON'T FORCE TOOL. It will do the
job better and safer at the rate for
which it was intended.
• USE RIGHT TOOL. Don't force
small tool or attachment to do the
job of a heavy-duty tool. Don't use
tool for purpose not intended.
° DRESS PROPERLY. Do not wear
loose clothing or jewelry. They can
2