Descargar Imprimir esta página

Craftsman 917.28862 Manual De Instrucciones página 26

Ocultar thumbs Ver también para 917.28862:

Publicidad

Idiomas disponibles

Idiomas disponibles

REPLACING BATTERY
n_a sWbARNING:Do not short battery terml-
y allowing awrench orany otherobject
to contactbothterminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatchbands, rings, etc.
Positive terminal must be connected first to
preventsparking from accidental grounding.
1. Lift hood to raised position.
2. Remove terminal cover.
3. Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
4. Install new batterywith terminals in same
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten securely.
7. Connect BLACK grounding cable to
negative (-) batteryterminalwith remain-
ing bolt and nut. Tighten securely
8. Close hood.
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractorto run poorly, stoprunning, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE
HOOD & GRILL ASSEMBLY
1. Raise hood.
2. Unsnap headlight
wire connector.
3. Stand in front of tractor.
Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing
hood, Ensure to recon-
nect the headlight
Wire connector.
_e
H°°d
He_dlight
Wire
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmission require removal for
service or replacement, it should be purged
after reinstaJlation and before operating the
tractor. See "PURGE TRANSMISSION" in
the Operation section of this manual.
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary,see engine manual,
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. If adjustment is necessary, see engine
manual.
26

Publicidad

loading