Craftsman 316.794791 Manual De Instrucciones página 7

The completed blower tube should l ook like Figure 6.
Elbow Tube
Throttle Cables Clamp
Flex Tube
Hose Clamp
Upper
On/Off Switch
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables (Fig.
7) as shown, making sure not to crimp the cables.
Zip Tie
Zip Tie
Fig. 7
Throttle Gri
First Lower
Blower Tube
Control
Adjusting the Throttle Grip
1. Move the throttle grip to a location on the upper blower tube
that is comfortable for you (Fig. 8).
A
Throttle Grip
Upper Blower Tube
Second Lower
Blower Tube
Fig. 8
2. Using a Torx T-20 Torx screwdriver, tighten the two screws at
the bottom of the throttle grip (Fig. 9).
Nozzle
Fig. 6
WARNING:
To avoid serious personal injury, make
sure that all four parts of the blower tube are locked in
place or firmly installed.
I
Fig. 9