Statement 2007 Electromagnetic Compatibility (EMC)
Environmental Conditions for Products Installed in
the European Union
Note
This equipment is intended to operate under the following environmental conditions with respect to EMC:
• A separate, defined location that is under the user's control.
• As a minimum, earthing and bonding shall meet the requirements of ETS 300 253:1995 or CCITT
• AC power distribution inside the building shall be, as a minimum, one of the following types (as defined
In addition, if equipment is operated in a domestic environment, radio-frequency interference may occur.
Statement 2017 Class A Notice for FCC
Note
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying
with FCC requirements for Class A digital devices. In that event, your right to use the equipment may be
limited by FCC regulations, and you may be required to correct any interference to radio or television
communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case users are required to correct the interference at their own
expense.
Regulatory Compliance and Safety Information - Cisco Secure Firewall 3105, 3110, 3120, 3130, 3140
10
Regulatory Compliance and Safety Information Cisco Secure Firewall 3105, 3110, 3120, 3130, 3140
K27:1996.
in IEC 60364-3:1993):
• TN-S
• TN-C
• TT
• IT