Operating Instructions
Operating Instructions
Controls
The controls will look like one of the following.
FAN SPEED
• Every time you push this button, it advances the setting as follows: {High ¡ Low ¡ Med ¡ High}
Cool
Energy
Saver
Fan
Timer
MODE
TIMER
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature
setting will raise 2°F after 30 min., and once again after another
30 min.
• Push Timer button to advance setting from 1Hour ¡ 2Hours ¡ ...
¡ 24 Hours maximum.
- START TIME
• If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1Hour ¡ 2Hours ¡ ...
¡ 24 Hours maximum.
MODE
Push this button to shift mode of operation from COOL ¡ ENERGY SAVER ¡ FAN.
-
- COOL:
• Fan runs continually for normal cooling operation.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will
check the room air temperature to determine if cooling is needed.
- FAN:
• Fan-only operation.
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its last setting.
18 Room Air Conditioner
'
F
F1 LOW
F2 MED
F3 HIGH
TEMP
FAN
POWER
SPEED
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
60°F to 86°F by increments of 1°F.
• The setting appears in the display.
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool
mode, High fan speed, Temperature setting at
72°F.