Honeywell HCE300 Serie Manual Del Propietário página 5

SAFEGUARD™ MOTION SENSOR (HCE323/HCE353 SERIES ONLY)
The Honeywell Safeguard™ Motion Sensor Digital Tower (Model series HCE323/HCE353 only) is equipped with
an additional safety feature. If an object is placed too close to the heater, the Motion Sensor Light (Fig. 2) will blink
to warn you that there is an obstruction. If the object is not removed, the sensor will disable the heater, turning the
heater off until the object is removed. The heater will restart after a few seconds once the object is removed.
Press the Safeguard™ Motion Sensor Button
2
Safeguard™ Motion Sensor Light
REMOTE CONTROL (HCE323/HCE353 SERIES ONLY)
The Honeywell Safeguard™ Motion Sensor Ceramic Digital Tower Heaters can be completely controlled with the
remote. This remote uses a button cell type battery which comes included in the remote.
To activate the battery, simply pull the plastic tab.
Place remote control in the holder in the back of the heater when not in use.
This product contains batteries, please do not dispose of them in a landfill, check local recycling.
FAHRENHEIT TO CELSIUS
Press and hold both Thermostat Control Buttons
NOTE: The Remote will not change between Fahrenheit and Celsius - only the controls on the heater.
For the HCE305 and HCE309 units, there is no option to change Fahrenheit and Celsius.
CLEANING AND STORAGE
• Periodic cleaning of the filter is recommended. Turn Off
Filter Cover and clean/vacuum the Filter. (Fig. 4)
NOTE: This pertains to all heaters in the HCE300 Series
with the exception of the HCE317 units. The HCE317
units do not contain a permanent filter.
• It is recommended that the Ceramic Tower Heater
be cleaned at least once a month and before off-
season storage.
• Turn Off and unplug heater. Use a dry cloth only to
clean the external surfaces of the heater. DO NOT USE
WATER, WAXES, POLISHES, OR ANY CHEMICAL
SOLUTION.
• Clean the Ceramic Tower Heater using the above-
mentioned steps. Wrap the cord around the unit. Place
in its original box and store it in a cool, dry place.
• This heater does not disassemble.
(Fig. 3) to turn on or off this feature.
3
for three seconds to change between Fahrenheit and Celsius.
and unplug heater. Allow it to cool. Remove the
4
NOTE: HCE317 series does not include a filter cover
5
Safeguard™ Motion Sensor Button
Filter Filter Cover