Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Display lights not working.
Unit not hot enough.
Unit too hot.
No heat, but light works.
No heat and no light.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco
for assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 414-671-6350
e-mail:
partsandservice@hatcocorp.com
OPTIONS AND ACCESSORIES
Support Post Accent Lighting
Support post accent lighting is available for all models as an
added option at the time of order. The accent lighting consists
of a vertical strip of red LED lights running up the center of each
support post.
Probable Cause
Power turned OFF.
LED lights defective.
Temperature control(s) set too low.
Heating element(s) not working.
Excessive air movement around unit.
Unit connected to incorrect power supply.
Temperature control(s) set too high.
Unit connected to incorrect power supply.
Temperature control(s) set too low.
Heating element(s) not working.
Power turned OFF.
Circuit breaker tripped.
ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
Move Power I/O (on/off) switch(es) to the I (on) position.
Contact Authorized Service Agent or Hatco for assistance.
Adjust temperature control(s) to higher setting. Refer to the
OPERATION section for procedures.
Contact Authorized Service Agent or Hatco for assistance.
Restrict or redirect air movement (i.e., air conditioning duct,
exhaust fan, exterior door) away from unit or install flip-up
doors on unit to contain heat and block air flow.
Contact Authorized Service Agent or Hatco for assistance.
Adjust Temperature control(s) to lower setting. Refer to the
OPERATION section for procedures.
Contact Authorized Service Agent or Hatco for assistance.
Adjust Temperature control(s) to higher settings. Refer to the
OPERATION section for procedures.
Contact Authorized Service Agent or Hatco for assistance.
Move Power I/O (on/off) switch(es) to the I (on) position.
Reset circuit breaker. If circuit breaker continues to trip,
contact Authorized Service Agent or Hatco for assistance.
Product Divider Rods
Stainless steel product divider rods are available as an
accessory.
HZM-DIV
Stainless Steel Divider Rod
12
WARNING
Corrective Action
Form No. HXMCEM1-0417
Publicidad
