Publicidad
Idiomas disponibles
Idiomas disponibles
Do not pull unit by high pressure hose.
Do not allow hose to be crushed or wrapped around objects.
WASHING WITH DETERGENT
WARNING: USE ONLY DETERGENTS DESIGNED FOR PRESSURE WASHERS.
Do not use household detergents, acids, alkalines, bleaches, solvents, flammable material, or
industrial grade solutions, which can damage the pump or cause property damage. Many detergents may
require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle. Always test in
an inconspicuous area before beginning.
Stop the engine.
Pour detergent in the soap tank. Use a funnel, if needed, to prevent accidental spilling of the
detergent outside the tank. If any detergent is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.
Install thelow pressure (black) nozzle into quick connect fitting of spray wand.
Start engine.
STARTING
WARNING: To reduce the risk of injury, read the pressure washer instruction manual and the
engine instruction manual before starting pressure washer.
DANGER: Risk of fluid injection and laceration. When using the high pressure setting, DO NOT allow
the high pressure spray to come in contact with unprotected skin, eyes, or with any pets or animals.
Serious injury will occur.
1. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating
of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine.
2. Check engine oil level.
3. Connect the water hose to the water source. Turn the water source on to remove all air from the hose.
When a steady stream of water is present, turn the water source off.
4.
Verify the filter screen is in water inlet of pump. NOTE: Convex side faces out.
5. Connect water source to pump inlet.
6. Connect high pressure hose to pump outlet.
7.Turn water source on.
8. Remove all air from the pump and high pressure hose by depressing trigger until a steady stream of
water is present.
9. Choose the correct nozzle for the job to be performed.
10. Start engine.
11. Depress trigger on gun to start water flow.
12. Release trigger to stop water flow.
SHUTTING DOWN
1. After each use, if you have applied chemicals, place detergent siphon hose into container of clean
water and draw clean water through chemical injection system to rinse system thoroughly.
NOTICE: Risk of property damage. Failure to do so could cause damage to the pump.
2. Turn engine off. See Engine Owner's Manual.
NOTICE: Risk of property damage. NEVER turn the water off with the engine running.
17
Publicidad
