ccei RNS-1 Instrucciones De Uso página 15

OPERATING INS-
TRUCTIONS
5. Installing the accessories
5.1. MFP-2 floater (RNS-1)
5.2. SE-3 sensor (RNS-2)
RNS-1, RNS-2 and NIVA 3 Module
The MFP-2 floater is fixed in the skimmer. Pre-
ferably use silicone or neoprene adhesive and
make sure not to block the removal of the filte-
ring basket.
A. Floater
The device acts as an "on-off" switch. The floa-
ter height varies with the water level and when it
is below the horizontal position (as in the photo
for example), it activates filling and pump pro-
hibition.
Once the level has been reached, the device stops
filling and restarts the filtration pump.
The SE-3 sensor is fixed in the skimmer. Prefe-
rably use silicone or neoprene adhesive.
A. High level
B. Low level
C. Ref. level
If the water level is above the high level (A), fil-
tration is authorised and automatic filling is stop-
ped.
If the water level is below the low level (B), the
device stops filtration (pump prohibition) and
activates filling until the high level is reached
(A).
v1.0EN
7