Descargar Imprimir esta página

Black and Decker LSW20 Manual De Instrucciones página 7

Escoba inalambrica con bateria de litio de 20 v max
Ocultar thumbs Ver también para LSW20:

Publicidad

Idiomas disponibles

Idiomas disponibles

After t hishappens, thecharger automatically
switches tothePack
Charging mode. This feature e nsures maximum b attery l ife. T he red
LED flashes i nthepattern i ndicated onthelabel when thehot
/ cold
pack delay is detected.
LEAVING THE BATTERY IN THE CHARGER
The charger and battery pack can be left connected with the green
LED glowing indefinitely. The charger will keep the battery pack
fresh and fully charged.
IMPORTANT CHARGING
NOTES
1. Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 60°F and 80°F
(16 °- 27°C). DO NOT charge the battery pack in an air temperature
below ÷40°F (+4.5°C), or above ÷105°F (+40.5°C). This is important
and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a
problem. To facilitate the cooling of the battery pack after use, avoid
placing the charger or battery pack in a warm environment such as
in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other
appliance
b. Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the
surrounding air temperature is approximately 60°F and 80°F
(16°- 27°C)
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO NOT
CONTINUE to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever
you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited
to, steel wool, aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
/k
WARNING:
Shock hozord Do not allow any liquid
to get inside charger. Never attempt to open the battery pack for any
reason, ff the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard (figure B). Make sure battery pack is fully
seated and fully latched into position.
TO REMOVE BATTERY PACK:
Depress the battery release button
in the back of the battery pack and
pull battery pack out of tool.

Publicidad

loading