Moulinex MAJESTUO FCM Instrucciones De Uso página 5

COFFEE PREPARATION
• Remove the water tank (E) and fill cold water. Fig. 3.
• Lift the coffee maker's lid (A) by pressing the lid button. Fig. 4.
• The number of cups is indicated by the water level indicator. Do not exceed 10-15 cups. Fig. 5.
• Place the carafe (G) closed on the heating base (C) by ensuring that it is properly in place in order
to activate the mechanism that allows the coffee to flow. Fig. 6.
• Make sure that the filter holder (F) is well inserted. Fig. 7. Place filter paper into the filter holder
(F). Make sure that the filter paper is fully open and properly in place in the filter holder. Fig. 8.
• Should some ground coffee be inadvertently poured into the water tank, refrain from starting the
cycle and first clean the water tank.
• The ground coffee could otherwise block the water circuit.
• Add 1 spoonful (H) of ground coffee per cup in filter paper. Do not exceed 10 spoonfuls (70 g). Fig. 9.
• Close the lid (A).
• If the coffee maker is in standby, press ACTIVATE button (11) to switch it on.
• Press ACTIVATE button (11) to start the cycle. The Brewing indicator (1) is displayed on the screen.
Fig. 10.
• When the cycle is completed with 2 beeps, the warm-up feature automatically turns on for 30
minutes. The Keep warm indicator (1) remains flashing on the display for the duration of the warm-
up period. Fig. 11.
• To stop the coffee maker during the cycle, press the ACTIVATE button (11).
Please note:
• The quantity of coffee in the carafe at the end of the cycle is less than the quantity of water poured
into the water tank, since the ground coffee and the filter absorb approximately 10% of it.
OTHER FUNCTIONS
– DELAYED START (PROG)
Setting the time of the Delayed Start
• Your appliance features a delayed start program.
• Make sure that the clock is set to the correct time. If this is not the case, follow the instructions in
the section SETTING THE CLOCK.
• Press the PROG button (2) to set the automatic start time. The PROG icon will appear on the
display. Fig. 12.
• Set the hour by pressing MINUS button (6) or PLUS button (7) and press PROG button (2) to
confirm, and the same way to set minute.
• The time setting is automatically confirmed after approximately 6 seconds or by pressing the PROG
button (2)
• Your coffee maker will start automatically at the programmed time. You can view the programmed
time at any time by pressing the PROG button (2) .
• To cancel the delayed start, hold down the PROG button (2) for 2 seconds.
– AROMA FUNCTION
Please note: The AROMA function gets more coffee flavours thanks to the pre-infusion phase.
• Press the AROMA button (4) before starting the coffee cycle to start the AROMA mode.
• The AROMA indicator light turns on. Fig. 13.
• To cancel the AROMA mode, press the AROMA button (4) again.
8
CLEANING
• To remove the used grounds, remove the filter and filter holder from the coffee maker. Fig. 14a.
• Discard the coffee grounds and the filter paper. Fig. 14b.
• Do not clean the appliance if it is still hot.
• Wash the removable filter holder using hot soapy water.
• Clean the coffee maker using a damp soft cloth or sponge. Never use
abrasive or strong products on any part of your coffee maker.
• To clean the stainless steel parts of your coffee maker, moisten a soft
cloth or sponge with hot water. Wipe them well using a dry cloth.
• For stubborn stains, use a cloth with some white vinegar.
• Do not immerse the appliance in water or under the tap.
DESCALING
Why is descaling important?
• Limescale builds up naturally in your coffee maker. Descaling helps to protect the coffee maker, ensure
a longer service life and consistently high-quality coffee over time. Limescale may permanently alter
the appliance's performance.
When is it time to descale?
• The frequency of descaling depends on water hardness and the number of coffee cycles. After
60 brew cycles, Descaling indicator (8) will light on to remind user that your machine requires
descaling.
• If descaling is not required by user, press MINUS button (6) to cancel.
How to descale your coffee maker
• Use a descaling solution or 0.5 L of white vinegar diluted in 0.5 L of cold or warm water. Fig. 15.
• Pour the solution into the water tank. Fig. 16.
• Do not put any coffee in the filter and press the ACTIVATE button (11) to start the descaling cycle.
Fig. 17.
• Please wait until the end of the cycle.
• To rinse the machine, start 2 complete 10-cup cycles with water, but without coffee.
• Repeat the operation as needed.
The guarantee does not cover coffee makers that are inoperative or which run badly due to a
lack of descaling.
EN
9