CASO DESIGN WaffleUp Manual Del Usuario página 23

3.4 Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfi l the following prerequisites:
•
The device must be placed on a fl at, stable and heat-resistant surface.
•
Do not use the device outdoors.
•
Do not operate the device near hot surfaces (e.g.hot plate), an open gas fl ame or in a
hot oven.
•
The device and the power cord must not come into contact with hot surfaces. The
device could be damaged.
•
Choose the setup location in such a way that children cannot reach the hot surfaces
of the device.
•
The device is not intended to be installed in a wall or a built-in cupboard.
•
Do not set up the device in a hot, wet or extremely damp environment or near fl am-
mable material.
•
The device requires suffi cient airfl ow to function properly.
•
Do not cover any openings on the device or block them.
•
The socket outlet must be easily accessible so that the connecting cable can be easily
disconnected in an emergency.
3.5 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instruc-
tions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequency)
on the rating plate with those of your electrical network. This data must agree in
order that no damages occur in the device. If in doubt, ask your qualifi ed electrician.
•
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fi re that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under the
ice maker or over hot or sharp surfaces.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installati-
on checked over by a qualifi ed electrician. The manufacturer cannot be made respon-
sible for damages that are caused by a missing or damaged protective conductor.
CASO Waffl eUp
DE
EN
IT
ES
NL
RUS
PL
PT
SE
TR
23