Publicidad
Idiomas disponibles
Idiomas disponibles
L
e
veling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need to
be adjusted. You can adjust them
manually by hand or by using a suitable
spanner.
To allow the doors to self-close, tilt the
top backwards by 10-15mm.
A
Adjustable bottom
feet
B
Front roller
C
Rear roller
A
B
A
N
ote:
If r
equired you may lay the refrigerator
on its back in order to gain access to
the base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied)
to the left side if required.
Warning!
When reversing the door, the appliance
must not be connected to the mains,
Ensure that the plug is removed from the
mains socket.
13
10- 15mm
C
Adjustable bottom feet
Tools you will need
Not provided
8mm socket wrench
Cross-shaped
screwdriver
Additional parts (in the plastic bag)
upper hinge-left
hinge cover-left screw hole cover-right
middle hinge-left
stop block-left*2
Allen Wrench(4mm)
Note: If required, you may lay the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the refrigerator.
To reverse the door, the following steps
generally recommended.
1. Stand the refrigerator upright. Open the
door to take out all door racks (to avoid
damage) and then close the door.
Caution!
Please slightly squeeze the door rack from
one side toward center, and then move it
upward when taking out the door racks.
Thin-blade
Putty knife
screwdriver
Monkey wrench
8mm wrench
Door stopper-left*2
Publicidad
