4.4. Disinfection (by hand)
Suitable disinfectants are; quaternary ammonium compounds, isopropyl alcohol,
chlorine bleach 0.5% and phenolic.
Apply disinfectant by cloth, spray or disinfectant wipe.
Following disinfection, wash off the product with clean warm water and dry
thoroughly using a soft cloth.
NOTE: Disinfectant products are corrosive in nature; failure to properly wash and dry
the product surface could leave a corrosive residue which may cause damage to the
product.
Adequate drying is crucial in the care and maintenance of this product.
Document No. 992044. Issue 6 – 24.10.22
CAUTION: Dilute all disinfectants in accordance with the manufacturer's
guidelines.
CAUTIONS:
Do not use concentrated bleaching disinfectant solutions, organic solvent
or abrasive powders in the cleaning or disinfection of products.
Do not expose any part of the product to excessive heat.
Do not press with hard or sharp objects.
Do not store on top of this product.
The product will be adversely affected and its life expectancy reduced if
the above cautions are not observed.