Publicidad
Idiomas disponibles
Idiomas disponibles
8
Display controls
Use your appliance according to the following control regulations, your appliance has the
corresponding functions as the control panels showed in the pictures below.
Controlling the temperature
Use your appliance according to the
following
control
appliance has the corresponding functions
as the control panels showed in the
pictures below.
Caution!
When you set a temperature, you set an
average
temperature
refrigerator cabinet. Temperatures inside
each compartment may vary from the
temperatures displayed on the panel,
depending on how much food you store
and where you place it. High or low room
temperature may also affect the actual
temperature inside the appliance.
1.
POWER
Press and hold the POWER button at least
3 seconds to enter/exit standby mode.
After entering the standby mode, the
POWER icon will light up, the temperature
area will display "OF", other icons will be
extinguished, and other key functions will
be invalid, until the original control state will
be restored after pressing the button again
to exit the standby mode.
2.
Freezer/Fridge conversion
Press and hold Freezer/Fridge conversion
button for 3 seconds to convert between
freezer compartment and fridge
compartment.
After that, the light will go out first,
and then turn on or flash once, which is
a normal phenomenon that the
control system has realized switching.
regulations,
your
for
the
whole
Caution！
Before changing the compartment
setting, make sure that the stored food
is suitable for new setting mode. If
not, please empty it first.
When the freezer mode is changed
to fridge mode, please open the door
for 5 minutes before putting in the food
that needs to be refrigerated.
When the fridge mode is changed
to freezer mode, please close the door
and run for 200 minutes before putting
in the food that needs to be frozen.
When the fridge mode is changed
to freezer mode, ensure there are no
bottled or canned drinks (especially
carbonated drinks) in the freezer
compartment. Bottles and cans may
explode.
3.
TEMP.
Press the TEMP. button to adjust the
temperature to the desired setting.
If you have set the Freezer
compartment type to Fahrenheit, the
temperature will be set in the following
sequence.
If you have set the Freezer
compartment type to Celsius, the
temperature will be set in the following
sequence.
If you have set the Fridge compartment
type to Fahrenheit, the temperature will
Publicidad
