Lenco MC-160 Manual Del Usuario página 13

5. Press the REC key at the front panel or remote control to start the recording, the REC logo would be
shown at the display
6. Press the REC key again to stop the recording. The REC logo would turn OFF. The system would
automatically play the recorded file. The audio would be stored as the last track at the USB flash stick.
7. LISTEN TO RECORD
1. Raise the dust cover
2. Turn on the unit by pressing the Standby/Volume Knob or standby key at remote control.
3. Press the MODE key at the front panel or remote control to select Phono mode.
4. Place a record on the turntable platter and set the player speed to match the record speed.
Note: When playing a single (a 45 rpm record) and/or records with large centre holes, use the 45 rpm
adaptor.
5. Remove the needle cartridge protective cover
Unlock the tone arm lock from the tone arm rest. Push the lift lever backward, the tone arm will gently rise up.
Gently move the tone arm to the desired position over the record and the turntable platter will begin to rotate
when the arm is moved towards it If Auto Stop Control Switch in ON. Release the tone arm onto the turntable
by pushing the lift lever forward and the vinyl record will begin to play.
If the Auto Control Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control
Switch is turned OFF, the record will NOT stop automatically when finished; you must push the lift lever
backward to raise the tone arm and place it back in the rest and then turn off the power to stop the turntable
from spinning.
Remark: AUTO STOP function applies to most 33RPM vinyl records. However, for very few vinyl records, it will
stop when it does not come to the end, or it will not stop when it comes to the end when AUTO STOP is ON.
NOTE: If your record stops before the last track finishes, set the AUTO STOP switch to OFF. Your record will now
play to the end, but you will have to stop the turntable rotation manually.
NOTE: Depending on the record length, AUTO STOP may be enabled before the end of the recording. Do not
rely on AUTO STOP alone to turn off playback.
8. LISTEN TO AUXILIARY INPUT
1. Using a 3.5mm Stereo cable (not included), connect an external audio device to the AUX IN socket at the
unit.
2. Turn on the unit by pressing the STANDBY/VOLUME Knob or standby key at remote control.
3. Press the MODE key at the front panel or remote control to select Aux mode, the display would show
"AUX".
4. Rotate the Standby/Volume Knob or VOL - & VOL + to adjust the volume and use the controls on the
external audio device to control the Playback/Volume functions
9. SLEEP FUNCTION
You can set the sleep timer for the system such that it can go to standby mode after certain of time by below
steps:
1. Turn on the unit by pressing the STANDBY/VOLUME Knob or standby key at remote control.